Hi, I had some time over the weekend so I decided to replace the lamps. The matter turned out to be trivially simple. It can be done in two ways, cutting the existing plugs on the harnesses or using adapters.
For those who don't want to cut the harnesses, you need to get the following
two sets of these plugs and sockets:
https://pl.aliexpress.com/item/1005007342074192.html
https://pl.aliexpress.com/item/1005001368141313.html
For those who choose to cut off the existing plugs,
all you need are these two plugs:
https://pl.aliexpress.com/item/1005003591879764.html
In addition, you will need two ordinary cables and a fuse to pull the permanent plus from the accumulator to both lamps.
All you need to do is insert everything into the 7 pin connector.
In pins 1 and 2 we plug in the control from the plug that was previously connected
to the halogen bulb ( low beam and high beam).
Pins 3 and 4 we leave empty.
To pin 5 we plug in the plus behind the battery.
To pin 6 and 7 we connect the ground and marker light.
That's all. Everything works.
Greetings.
For those who don't want to cut the harnesses, you need to get the following
two sets of these plugs and sockets:
https://pl.aliexpress.com/item/1005007342074192.html
https://pl.aliexpress.com/item/1005001368141313.html
For those who choose to cut off the existing plugs,
all you need are these two plugs:
https://pl.aliexpress.com/item/1005003591879764.html
In addition, you will need two ordinary cables and a fuse to pull the permanent plus from the accumulator to both lamps.
All you need to do is insert everything into the 7 pin connector.
In pins 1 and 2 we plug in the control from the plug that was previously connected
to the halogen bulb ( low beam and high beam).
Pins 3 and 4 we leave empty.
To pin 5 we plug in the plus behind the battery.
To pin 6 and 7 we connect the ground and marker light.
That's all. Everything works.
Greetings.
