Quantcast
Channel: Ford Flex Forum
Viewing all articles
Browse latest Browse all 1408

Technical / How-To Articles • Re: How To Add Lane-Keep Assist

$
0
0
I have been lurking a lot with this project and finally upgraded my 3d printer where I can print in ASA (Among other materials) and get good quality prints. But one of the things that I have wondered is the metal bracket you get from AliExpress, why do you not use "specialty" Rearview Mirror JBWeld? I figured when they are done on official cars that is what was used. (Ignorance question since I have only done one other mirror in my life)


Keep up the Good work, and I plan to start this project next month once it is not hotter than could be outside.

Viewing all articles
Browse latest Browse all 1408

Trending Articles