In the middle of replacing all my components behind my timing cover and I need some assistance on the cam phasers torque sequence.
1. Torque to 30 ftlb - did that
2. Loosen 1 full turn - did that
3. Tighten back down to 89 inch pounds. ** This is where I'm stuck, I have a 1/4 drive torque wrench that measures inch pounds but there is no way to get that 1/2 drive t55 to it. Is there something I'm missing? Is this an error? I tried mathing it out and I don't think the 7.4 ft lb is a wise number to run on to torque these down to then do my 90' turn. Far as I know there is no t55 at all that goes to my 1/4 drive and there doesn't seem to be a 1/2 drive that does inch pounds. Any help is appreciated
1. Torque to 30 ftlb - did that
2. Loosen 1 full turn - did that
3. Tighten back down to 89 inch pounds. ** This is where I'm stuck, I have a 1/4 drive torque wrench that measures inch pounds but there is no way to get that 1/2 drive t55 to it. Is there something I'm missing? Is this an error? I tried mathing it out and I don't think the 7.4 ft lb is a wise number to run on to torque these down to then do my 90' turn. Far as I know there is no t55 at all that goes to my 1/4 drive and there doesn't seem to be a 1/2 drive that does inch pounds. Any help is appreciated